تراشکاری ارتعاشی با اولتراسونیک یک جهته و بیضوی بر روی قطعه کار In738

نوع مقاله : مقاله پژوهشی

نویسندگان

1 دانشگاه کاشان

2 دانشگاه تربیت مدرس

3 دانشگاه امیرکبیر

چکیده

در این تحقیق تراشکاری ارتعاشی، تراشکاری ارتعاش بیضوی و تراشکاری معمولی بر روی قطعه کار سوپر آلیاژ In738 مورد آزمایش قرار گرفته است. این آزمایش‌ها با ابزار الماس تک کریستال و دستگاه تراش CNC انجام شد. جهت اعمال ارتعاش در فرآیند تراشکاری ارتعاشی در جهت سرعت برشی و در فرآیند تراشکاری ارتعاش بیضوی در جهت سرعت برشی و عمق برش می‌باشد. فرکانس ارتعاشی 36.16 Khz و دامنه می‌باشد. نتایج آزمایش‌ها نشان داد که نیروی ماشین‌کاری و زبری سطح در تراشکاری ارتعاش بیضوی، کمتر از تراشکاری ارتعاشی و تراشکاری معمولی است. در فرآیند تراشکاری ارتعاش بیضوی، زبری سطح هم در جهت برشی و هم در جهت پیشروی، کمتر از دو فرآیند دیگر می‌باشد. سپس با تغییر پارامترهای ماشین‌کاری شامل، سرعت برشی، پیشروی و دامنه ارتعاش، نیروی ماشین‌کاری و زبری سطح در فرآیندهای فوق بررسی و مقایسه گردید.

کلیدواژه‌ها


عنوان مقاله [English]

Vibration Cutting and Elliptical Ultrasonic Vibration Assisted Turning of In738 Work-Pieces

نویسندگان [English]

  • Saeed Amini 1
  • Mohammad javad Nategh 2
  • amir abdollah 3
چکیده [English]

Vibration cutting (VC), elliptical vibration cutting (EVC) and ordinary cutting (OC) of In738 work-pieces have been experimentally investigated in the present research. The experiments were carried out by using single crystal diamond tool and ultra-precision CNC lathe. Vibration frequency is 36.16KHz and the amplitude is . The influence of various cutting parameters including cutting speed, feed-rate, vibration amplitude and phase angle on the cutting force, surface roughness and tool life have been studied and the results have been compared. The results indicate that the cutting force in EVC is much less than the two other processes. The surface roughness in both the cutting and feed directions was also less than those in other processes.

کلیدواژه‌ها [English]

  • Vibration cutting (VC)
  • elliptical vibration cutting (EVC)
  • In738 machining
CAPTCHA Image