Determine the Optimal Algorithm of Priority Panel in CNG Refueling Station to Minimize Energy Cost

Document Type : Original Article

Authors

Morteza Saadat-targhi ¹

Javad Khadem ²

Mahmood Farzaneh-Gord ³

¹ Esfarayen University of Technology, Esfarayen, North Khorasan, Iran

² Department of Mechanical Engineering, University of Birjand, Birjand, Iran

³ Mechanical Engineering Department, Ferdowsi University of Mashhad, Mashhad, Iran.

10.22067/jacsm.2021.72060.1052

Abstract

The fast filling process is the main process that occurs in the CNG refueling station. The main objective of the present study is to apply a thermodynamic analysis for a complete modeling of a CNG refueling station with several consecutive refueling . The results of the thermodynamic analysis have been validated against the experimental data and previous studies. The AGA8 Equation of State has been used to calculate the thermodynamic properties of CNG. There are many researches concentrated on the thermodynamic modeling of CNG refueling station, but didn't address the optimal algorithm of priority panel. Filling time minimizing, filling mass maximizing and average specific energy consumption minimizing have been employed as the objective function for the optimization problem. Finally, the optimal algorithm of priority panel has been determined as the main goal of the present study. The conclusive results of the optimization problem are presented. Achieving more accurate modeling and modeling the process of several consecutive refueling is one of the most important results of the present study. The optimal algorithm of priority panel are obtained for PPM225 algorithm . An economic analysis is performed to see the results more clearly. The results of the economic analysis show that 65,700,000,000 Rials (43,800,000 kWh) can be saved in one year.

Keywords

Modeling

Natural gas

Fast filling

Optimization

Subjects

• Thermodynamics

---

References

1. Kountz, K., " Modeling The Fast Fill Process in Natural Gas Vehicle Storage Cylinders", American Chemical Society Paper at 207^th National ACS Meeting, March, (1994).
2. Farzaneh-Gord, M., Hashemi, S., Farzaneh-Kord, S., "Thermodynamics Analysis of Cascade Reserviors Filling Process of Natural Gas Vehicle Cylinders", World Applied Sciences Journal, Vol. 5, No. 2, pp. 143-149, (2008).
3. Farzaneh-Gord, M., Deymi-Dashtebayaz, M., Rahbari, H. R., "Studying effects of storage types on performance of CNG filling stations", Journal of Natural Gas Science and Engineering, Vol. 3, No. 1, pp. 334-340, (2011).
4. Farzaneh-Gord, M., Deymi-Dashtebayaz, M., Rahbari, H. R., "Optimising Compressed Natural Gas filling stations reservoir pressure based on thermodynamic analysis", International Journal of Exergy, Vol. 10, No. 3, pp. 299-320, (2012).
5. Mahdizadeh Rokhi, M. D. D. M., Farzaneh Gord, M., Abbasi, M., "An investigation in the effect of natural gas composition on the filling processes of an automobile CNG cylinder in order to define the optimized conditions of the fuel transmission station", Modares Mechanical Engineering, Vol. 13, No. 9, pp. 103-110, (2013).
6. Khamforoush, M., Moosavi, R., Hatami, T., "Compressed natural gas behavior in a natural gas vehicle fuel tank during fast filling process: Mathematical modeling, thermodynamic analysis, and optimization", Journal of Natural Gas Science and Engineering, Vol. 20, No. 0, pp. 121-131, (2014).
7. Deymi-Dashtebayaz, M., Farzaneh Gord, M., Rahbari, H. R., "Studying transmission of fuel storage bank to NGV cylinder in CNG fast filling station", Journal of the Brazilian Society of Mechanical Sciences and Engineering, Vol. 34, pp. 429-435, (2012).
8. Khadem, J., Saadat-Targhi, M., Farzaneh-Gord, M., "Mathematical modeling of fast filling process at CNG refueling stations considering connecting pipes", Journal of Natural Gas Science and Engineering, 26, pp. 176-184, (2015).
9. Saadat-Targhi, M., Khadem, J., Farzaneh-Gord, M., "Thermodynamic analysis of a CNG refueling station considering the reciprocating compressor", Journal of Natural Gas Science and Engineering, Vol. 29, pp. 453-461, (2016).
10. Kagiri, C., Xiaohua Xia, L., "Optimization of a compressed natural gas station operation to minimize energy cost", Energy Procedia, 142, pp. 2003-2008, (2017).
11. Kagiri, C., M.Wan jiru, E., Zhang, L., Xia, X., "Optimized response to electricity time-of-use tariff of a compressed natural gas fuelling station ", Applied Energy, Vol. 222, pp. 244-256, (2018).
12. Farzaneh-Gord, M., Saadat-Targhi, M., Khadem, J., "Selecting optimal volume ratio of reservoir tanks in CNG refueling station with multi-line storage system", International Journal of Hydrogen Energy, Vol. 41, No. 40, pp. 25453-25473, (2017).
13. Menon, E. S., "Transmission Pipeline Calculations and Simulations Manual" Elsevier Science, pp.710-745, (2014).
14. Starling, K. E., "A. G. A. O. S. T. M. Committee, Compressibility and Super compressibility for Natural Gas and Other Hydrocarbon Gases" Operating Section, American Gas Association, (1986).
15. George, D., "CNG Sampling, in Natural gas" sampling technology conference, New Orleans, Louisiana, pp. 72-80, (2014).
16. Imran Khan, M., Yasmin, T., Shakoor, A., "Technical overview of compressed natural gas (CNG) as a transportation fuel", Renewable and Sustainable Energy Reviews, Vol. 51, No. 0, pp. 785-797, (2015).
17. ilna.ir/367451, 5/2/(2016)