The fuller die, which is used for elongated components, is a type of perform die employed in the closed-die forging process. In this research, using the finite-element method and the model test technique, both the required load and material flow are studied for the four-blow fullering operation. The experiments are conducted using lead as the model material and steel tools. Comparison of the numerical predictions and experimental results show a good agreement between them. For the extension of various process variables, FEM simulations are performed using ANSYS commercial software. Then, by means of linear regression and based on the finite-element results, some useful relationships are proposed for prediction of elongation, sideways spread and the required load for the four-blow fullering process. The designers can use the results of this investigation for prediction of elongation, sideways spread and fullering load instead of time consuming and expensive experiments
khalili, M., Fereshteh-Saniee, F., & Poursina, M. (2010). Estimation of Load and Elongation in the Four-Blow Fullering Process. Journal Of Applied and Computational Sciences in Mechanics, 21(2), 59-70. doi: 10.22067/fum-mech.v21i2.8292
MLA
maryam khalili; Framarz Fereshteh-Saniee; Mehrdad Poursina. "Estimation of Load and Elongation in the Four-Blow Fullering Process", Journal Of Applied and Computational Sciences in Mechanics, 21, 2, 2010, 59-70. doi: 10.22067/fum-mech.v21i2.8292
HARVARD
khalili, M., Fereshteh-Saniee, F., Poursina, M. (2010). 'Estimation of Load and Elongation in the Four-Blow Fullering Process', Journal Of Applied and Computational Sciences in Mechanics, 21(2), pp. 59-70. doi: 10.22067/fum-mech.v21i2.8292
VANCOUVER
khalili, M., Fereshteh-Saniee, F., Poursina, M. Estimation of Load and Elongation in the Four-Blow Fullering Process. Journal Of Applied and Computational Sciences in Mechanics, 2010; 21(2): 59-70. doi: 10.22067/fum-mech.v21i2.8292
Send comment about this article