Journal Of Applied and Computational Sciences in Mechanics

Journal Of Applied and Computational Sciences in Mechanics

Simulation of the effect of replacing gasoline with gaseous fuel on TU5 engine performance

Document Type : Original Article

Authors
Javad Khadem 1
Ali Asadi 2
Asadollah Bastami 1
1 Department of Mechanical Engineering, Faculty of Engineering, University of Birjand, Birjand, Iran
2 Department of Mechanical Engineering, Faculty of Engineering, Bozorgmehr University of Qaenat, Qaen
10.22067/jacsm.2025.92686.1326
Abstract
In recent years, the substitution of gaseous fuels for liquid fuels in internal combustion engines has received considerable attention. In this paper, the effect of using gaseous fuels such as methane and propane instead of gasoline on the performance parameters of the TU5 engine, which is one of the most widely used engines in the country's automotive industry, has been simulated using the one-dimensional fluid dynamics software GT-Power. The results showed that using gaseous fuel, due to occupying a certain volume of air, led to a decrease in volumetric efficiency, with the reduction in volumetric efficiency being greater for methane compared to propane. Additionally, using gaseous fuel in the gasoline engine, without making significant changes such as altering the compression ratio, resulted in a reduction in brake power and torque. The results also showed that the optimal spark timing also changes simultaneously with the change in the type of fuel in the engine. The comparison between simulation and experimental results showed relatively good agreement.
Keywords
Engine TU5
Gas Fuel
Spark Timing
Simulation
GT-Power
Subjects
[1] M. Yadegari and M. Ghassemi, "Investigation of the Effects of Temperature, Mass Flow Rate of the Injected Fuel, Pore Diameter, Porosity and Ambient Pressure on the Amount of Pollutants in the Combustion Chamber," Iranian Journal of Mechanical Engineering Transactions of the ISME, vol. 23, no. 1, pp. 122–146, 2022. https://doi.org/10.30506/jmee.2022.547922.1282
[2] A. Asadi and M. Yadegari, "The study of the effect of fuel dilution in methane/air counterflow diffusion flames on the emission of environmental pollutants," Journal of Mechanical Engineering, vol. 33, no. 6, pp. 25–34, 2025. (In Persian) https://doi.org/10.30506/mmep.2024.2025565.2166
[3] M. Saadat-targhi, J. Khadem, and M. Farzaneh-Gord, "Determine the optimal algorithm of priority panel in CNG refueling station to minimize energy cost," Journal of Applied and Computational Sciences in Mechanics, vol. 32, no. 2, pp. 201–216, 2021. (In Persian) https://doi.org/10.22067/jacsm.2021.72060.1052
[4] A. Mohammadi, M. Varmazyar, and M. Soleimani, "Influence of alumina nanoparticles on the combustion process with the help of homogeneity factor in a compression ignition engine," Journal of Applied and Computational Sciences in Mechanics, vol. 31, no. 2, pp. 157–175, 2020. (In Persian) https://doi.org/10.22067/fum-mech.v31i2.82063
[5] M. Ghazikhani and M. S. Shahab-Ahmadi, "Investigation of the exhaust silencer irreversibility and the sound intensity emitted from the exhaust in diesel engines," Journal of Applied and Computational Sciences in Mechanics, vol. 21, no. 1, pp. 75–88, 2010. (In Persian) https://doi.org/10.22067/fum-mech.v21i1.7713
[6] C. Pithawalla, "Comparative assessment on performance of multi cylinder engine using CNG, LPG and petrol as a fuel," SAE Technical Paper, no. 01-1056, 2005.
[7] A. H. Shamekhi, Z. N. Khatib, and A. Shamekhi, “A comprehensive comparative investigation of compressed natural gas as an alternative fuel in a bi-fuel spark ignition engine,” 2008.
[8] K. Rezapour, K. S. Ebrahimi, A. Wood, and A. Nikranjbar, "Simulation and modeling of bi-fuel engine for improving the performance parameters," SAE Technical Paper, no. 2010-01-2034, 2010. https://doi.org/10.4271/2010-01-2034
[9] K. Rezapour, "Availability analysis of a bi-fuel SI engine model for improvement its performance," International Journal on Technical and Physical Problems of Engineering, vol. 4, no. 2, pp. 115–121, 2012.
[10] A. Firouzgan, "An experimental assessment of compression ratio and evaluation of aluminium cylinder head in bi-fuel (gasoline+CNG) engines," The Journal of Engine Research, no. 18, 2010.
[11] E. Ramjee and K. Vijaya Kumar, "Performance analysis of a 4-stroke SI engine using CNG as an alternative fuel," Indian Journal of Science and Technology, vol. 4, no. 7, pp. 801-804, 2011.
[12] T. Mamidi and G. Suryawnshi, "Investigations on S.I. engine using liquefied petroleum gas (LPG) as an alternative fuel," International Journal of Engineering Research and Applications, vol. 2, no. 1, pp. 362–367, 2012.
[13] W. Ge, F. D. Chuahy, P. Zhang, R. Sankaran, D. Splitter, D. DelVescovo, T. Lu, and P. Zhao, "A direct numerical simulation study of the dilution tolerance of propane combustion under spark-ignition engine conditions," Combustion and Flame, vol. 247, p. 112495, 2023. https://doi.org/10.1016/j.combustflame.2022.112495
[14] M. Gore, K. Nonavinakere Vinod, and T. Fang, "Experimental investigation of gaseous mixtures of ethane, methane, and carbon dioxide as an alternative to conventional fuel in spark ignition engines," Journal of Energy Resources Technology, vol. 145, no. 3, p. 032301, 2023. https://doi.org/10.1115/1.4055201
[15] F. Solferini de Carvalho, A. Peñaranda Mendoza, L. Ribeiro dos Santos, C. Henrique Rufino, E. Malheiro de Oliveira, M. Ferreira Silva, E. Blanco Machin, D. Travieso Pedroso, and P. Teixeira Lacava, "Experimental study of the methane and producer gas blends in an optical spark ignition engine: Combustion characteristics, thermodynamics and emissions," International Journal of Engine Research, vol. 24, no. 6, pp. 2708–2726, 2023. https://doi.org/10.1177/14680874221131117
[16] J. Ronsman, J. Valla, O. Nsaif, and A. Dempsey, "Experimental investigation of prechamber enabled mixing-controlled combustion with natural gas – A pathway to ultra-low methane emissions," Fuel, vol. 392, p. 134757, 2025. https://doi.org/10.1016/j.fuel.2025.134757
[17] T. I. Banji, G. Arney, and D. B. Olsen, "Fuel injection optimization for large-bore two-stroke natural-gas engines," Energies, vol. 18, no. 3, p. 624, 2025. https://doi.org/10.3390/en18030624
[18] R. Yang, Z. Yin, Y. Yan, J. Ou, T. Xie, Z. Liu, and J. Liu, "Investigating the effect of ammonia addition on the performance of a heavy-duty natural gas spark ignition engine operated at stoichiometric conditions," Journal of Energy Resources Technology, Part A: Sustainable and Renewable Energy, vol. 1, no. 2, 2025. https://doi.org/10.1115/1.4066878
[19] L. F. Alvarez, O. Askari, and C. E. Dumitrescu, "Effect of blending ammonia with natural gas hydrocarbons on the performance of a heavy-duty spark ignition engine," Journal of Engineering for Gas Turbines and Power, vol. 147, no. 9, 2025. https://doi.org/10.1115/1.4067405
[20] S. Lee, N. Iida, and O. Lim, "Numerical investigation on laminar burning velocity and flame temperature characteristics of dedicated EGR SI engine fueled with methane and propane under different equivalence ratio," International Journal of Automotive Technology, pp. 1–3, Feb. 2025. https://doi.org/10.1007/s12239-025-00217-9
[21] M. Rabeti, O. Jahanian, A.A. Ranjbar, and S.M. Safieddin Ardebili, "Investigations on Semi-Empirical Heat Transfer Models for Heat Flux of HCCI Engine Fueled with Natural Gas," Modares Mechanical Engineering, vol. 21, no. 12, pp.797-810, 2021. (In Persian) https://dor.isc.ac/dor/20.1001.1.10275940.1400.21.12.1.1
[22] M. Taghizadeh, "Modeling and design of a VVT system for the Peugeot 206 engine," Master Thesis, Khajeh Nasir Toosi University of Technology, 2013. (In Persian)
Send comment about this article
Enter Name.
Enter a valid email address.
Enter a vaid affiliation.
Enter comments (At leaset 10 words)
CAPTCHA Image
Enter Security Code Correctly.