Journal Of Applied and Computational Sciences in Mechanics

Journal Of Applied and Computational Sciences in Mechanics

Investigation of the Effect of Geometric Defects and Temperature Changes on the Fracture Behavior of Boron Carbide Monocrystalline Structure by Molecular Dynamics

Document Type : Original Article

Authors
Alireza Albooyeh 1
Ali Dadrasi 2
Mohammadamin Razavikia 1
1 Mechanical Engineering,, Damghan University, Damghan, Iran
2 Assistant Professor, Mechanical Engineering,, Azad Shahrood University, Shahrood, Iran
10.22067/jacsm.2022.74654.1087
Abstract
Boron carbid (BC3) is a new two-dimensonal structure that exhibits unique chemical, thermal and mechanical peroperties. In this paper the mechanical properties of BC3 structure were investigated by using of molecular dynamics simulation. By using of Tressof potential and periodic boundry conditions, two elements of circular defect and followed temperature changes on BC3 structure were analyzed. The results of tensile test on boron carbide structure showed that the lowest young’s modulus as well as the failure stress and strain at the breaking point occurred in sample with central defect. Also, by changing the position of the defect towards the edges, the mechanical properties increased. By changing the position of the defect from the center of the structure to the edges, the values of young's modulus, stress and strain at the breaking point in th zigzag direction increased by 1.29%, 15.1% and 20%, respectively. Examination of temperature changes from 100K to 1000K showed that the increase in temperature reduced the mechanical properties, so that the value of the young's modulus decreased from 781.21 GPa at 100K to 616.19 GPa at 1000K. Also, the amount of stress and strain at the breaking point for the mentioned temperature compared to 100 K decreased by 43.05% and 51.08%, respectively.
Keywords
Molecular dynamics
Mechanical properties
Simulation
boron carbid
Defect
Subjects
  1. Bondarev, A. V., Fraile, A., Polcar, T., and Shtansky, D. V., "Mechanisms of Friction and Wear Reduction by H-BN Nanosheet and Spherical W Nanoparticle Additives to Base Oil: Experimental Study and Molecular Dynamics Simulation", Tribology International, 151, Pp. 106493, (2020).
  2. Aghdasi, P., Ansari, R., Rouhi, S., Yousefi, S., Goli, M., and Soleimani, H.,"Investigating Elastic and Plastic Characteristics of Monolayer Phosphorene under Atomic Adsorption by the Density Functional Theory", Physica B: Condensed Matter, 600, Pp. 412603, (2021).
  3. Takari, A., Ghasemi, A. R., Hamadanian, M., Sarafrazi, M., and Najafidoust, A. "Molecular Dynamics Simulation and Thermo-Mechanical Characterization for Optimization of Three-Phase Epoxy/TiO2/SiO2 Nano-Composites", Polymer Testing, 93, Pp. 106890, (2021).
  4. Sunnardianto, G. K., Bokas, G., Hussein, A., Walters, C., Moultos, O. A., and Dey, P., "Efficient Hydrogen Storage in Defective Graphene and its Mechanical Stability: A Combined Density Functional Theory and Molecular Dynamics Simulation Study", International journal of Hydrogen energy, 46, Pp. 5485-5494, (2021).
  5. Novoselov, K. S., Geim, A. K., Morozov, S. V., Jiang, D. E., Zhang, Y., Dubonos, S. V., and Firsov, A. A., "Electric Field Effect in Atomically Thin Carbon Films", Science, 306, Pp. 666-669, (2004).
  6. Rajabi, M., Zarei, D., Rashed, Gh. R., “An overview of the structure and properties of polymer / graphene nanocomposites,” Journal of Studies in the World of Color, Vol. 2, 23001, (2012) (In Persian).
  7. Lee, C., Wei, X., Kysar, J. W., and Hone, J., "Measurement of the Elastic Properties and Intrinsic Strength of Monolayer Graphene", Science, 321, Pp. 385-388, (2008).
  8. Yu Q., Jauregui, L. A., Wu W., Colby R., Tian J., Su Z., Cao H., Liu Z., Pandey D., and Wei D., "Control and Characterization of Individual Grains and Grain Boundaries in Graphene Grown by Chemical Vapour Deposition", Nature Materials, 10, Pp. 443-449, (2011).
  9. Kim, K. S., Zhao, Y., Jang, H., Lee, S. Y., Kim, J. M., Kim, K. S., ... & Hong, B. H. Kim, K. S., Zhao, Y., Jang, H., Lee, S. Y., Kim, J. M., Kim, K. S., & Hong, B. H., "Large-Scale Pattern Growth of Graphene Films for Stretchable Transparent Electrodes", Nature, 457, Pp. 706-710, (2009).
  10. Grieshammer, S., Momenzadeh, L., Belova, I. V., and Murch, G. E., "Ionic and Thermal Conductivity of Pure and Doped Ceria by Molecular Dynamics", Solid State Ionics, 355, Pp. 115424, (2020).
  11. Zamani, S. M. M., and Behdinan, K., "A Molecular Dynamics Study of the Mechanical and Electrical Properties of Polydimethylsiloxane-Ni Conductive Nanocomposites", Composites Science and Technology, 200, Pp. 108463, (2020).
  12. Djaili, S., Gueddim, A., Guibadj, A., and Bouarissa, N., "Temperature Dependence of the Optical Properties of MgO: Ab Initio Molecular Dynamics Calculations", Optik, 200, Pp. 163421, (2020).
  13. Islam, M., Thakur, M. S. H., Mojumder, S., Al Amin, A., and Islam, M. M., "Mechanical and vibrational characteristics of functionally graded Cu–Ni nanowire: a molecular dynamics study," Composites Part B: Engineering, 198, Pp. 108212, (2020).
  14. Thevenot, F. (1991). "A review on boron carbide." Pp. 59-88.
  15. Domnich, V., Reynaud, S., Haber, R. A., and Chhowalla, M., "Boron carbide: structure, properties, and stability under stress," Journal of the American Ceramic Society, 94, Pp. 3605-3628, (2011).
  16. Werheit, H., "Boron-rich solids: a chance for high-efficiency high-temperature thermoelectric energy conversion," Materials Science and Engineering: B, 29, Pp. 228-232, (1995).
  17. Emin, D., "Unusual properties of icosahedral boron-rich solids," Journal of Solid State Chemistry, 179, Pp. 2791-2798, (2006).
  18. Tanaka, H., Kawamata, Y., Simizu, H., Fujita, T., Yanagisawa, H., Otani, S., and Oshima, C., "Novel macroscopic BC3 honeycomb sheet," Solid state communications, 136, Pp. 22-25, (2005).
  19. Rao B. S., "Ceramic Powders for High-tech Applications", Universities Press, (1995).
  20. Durandurdu M., "Ab initio simulation of amorphous BC3," Computational Materials Science, 178, Pp. 109622, (2020).
  21. Mrudul, M. S., Thomas, S., and Ajith, K. M., "Anharmonicities in the temperature-dependent bending rigidity of BC3 monolayer," Journal of Physics and Chemistry of Solids, 146, Pp. 109574, (2020).
  22. Korotaev, P., Pokatashkin, P., and Yanilkin, A., "The role of non-hydrostatic stresses in phase transitions in boron carbide," Computational Materials Science, 121, Pp. 106-112, (2016).
  23. Zahedi, R. K., Shirazi, A. H. N., Alimouri, P., Alajlan, N., and Rabczuk, T., "Mechanical properties of graphene-like BC3; a molecular dynamics study," Computational Materials Science, 168, Pp. 1-10, (2019).
  24. Molaei, F., Eshkalak, K. E., Sadeghzadeh, S., and Siavoshi, H., "Assessing mechanical properties of single-layer B-doped C3N and N-doped BC3 nanosheets and their hybrid," Computational Materials Science, 192, Pp. 110368, (2021).
  25. Esfahani, M. N., Jabbari, M., Xu, Y., and Soutis, C., "Effect of nanoscale defects on the thermal conductivity of graphene," Materials Today Communications, 26, Pp. 101856, (2021).
  26. Albooyeh, A. R., Dadrasi, A., and Mashhadzadeh, A. H., "Effect of point defects and low-density carbon-doped on mechanical properties of BNNTs: A molecular dynamics study," Materials Chemistry and Physics, 239, Pp. 122107, (2020).
  27. Li, L., Zhang, M. W., and Zhao, Z. Z., "Molecular dynamics analysis of the effect of laser and defects on the micro-structure of fused silica," Journal of Electronic Science and Technology, 18, Pp. 100045, (2020).
  28. Islam, Z., and Haque, A., "Defects and grain boundary effects in MoS2: A molecular dynamics study," Journal of Physics and Chemistry of Solids, 148, Pp. 109669, (2021).
  29. Zhang, Y., and Huang, H., "Stability of single-wall silicon carbide nanotubes–molecular dynamics simulations," Computational Materials Science, 43, Pp. 664-669, (2008).
  30. Prieve, D. C., and Russel, W. B., "Simplified predictions of Hamaker constants from Lifshitz theory," Journal of Colloid and Interface Science, 125, no. 1, Pp. 1-13, (1988).
  31. Byggmästar, J., Hodille, E. A., Ferro, Y., and Nordlund, K., "Analytical bond order potential for simulations of BeO 1D and 2D nanostructures and plasma-surface interactions," Journal of Physics: Condensed Matter, 30, Pp. 135001, (2018).
  32. Dadrasi, A., Fooladpanjeh, S., Eshkalak, K. E., Sadeghzadeh, S., and Saeb, M. R., "Crack Pathway Analysis in Graphene-Like BC3 Nanosheets: Towards a Deeper Understanding", Journal of Molecular Graphics and Modelling, 107, Pp. 107980, (2021).
  33. Stukowski, A., "Visualization and Analysis of Atomistic Simulation Data with OVITO–the Open Visualization Tool", Modelling and simulation in materials science and engineering, 18, Pp. 015012, (2009).
  34. Mortazavi, B., Ahzi, S., Toniazzo, V. and Rémond, Y., "Nitrogen Doping and Vacancy Effects on the Mechanical Properties of Graphene: A Molecular Dynamics Study", Physics Letters A, 376, Pp. 1146-1153, (2012).
  35. Fang, T., Chang, W. and Yang, J. C., "Temperature Effect on Mechanical Properties of Graphene Sheets under Tensile Loading", Digest Journal of Nanomaterials and Biostructures, 7, Pp. 1811-1816, (2012).
  36. Dadrasi, A., Fooladpanjeh, S., Albooyeh, A., Salmankhani, A., Mashhadzadeh, A. H. and Saeb, M. R., "A Theoretical Insight into the Fracture Behavior of the Edge-Cracked Polycrystalline BC3 Nanosheets", Computational Materials Science, 192, Pp. 110345, (2021).
  37. Dehaghani, M. Z., Mashhadzadeh, A. H., Salmankhani, A., Karami, Z., Habibzadeh, S., Ganjali, M. R., & Saeb, M. R., "Fracture Toughness and Crack Propagation Behavior of Nanoscale Beryllium Oxide Graphene-Like Structures: A Molecular Dynamics Simulation Analysis", Engineering Fracture Mechanics, 235, Pp. 107194, (2020).
  38. Li, J., Dong, L., Xie, H., Meng, W., Zhang, X., Zhang, J. and Zhao, W., "Molecular Dynamics Simulation of Nanocrack Propagation Mechanism of Polycrystalline Titanium under Tension Deformation in Nanoscale", Materials Today Communications, 26, Pp. 101837, (2021).
  39. Chang, X., Ji, Y., and Li, H., "Mechanical Properties of PtS2 Monolayer with Rectangular Defects: A Molecular Dynamics Study", Computational Materials Science, 196, Pp. 110552, (2021).
  40. Guo, F. L., Tan, D., Wu, T., Huang, P., Li, Y. Q., Hu, N., and Fu, S. Y., "Experimental Characterization and Molecular Dynamics Simulation of Thermal Stability, Mechanical Properties and Liquid Oxygen Compatibility of Multiple Epoxy Systems for Cryotank Applications", Extreme Mechanics Letters, 44, Pp. 101227, (2021).
  41. Chowdhury, E. H., Rahman, M. H., Fatema, S., and Islam, M. M., "Investigation of the Mechanical Properties and Fracture Mechanisms of Graphene/WSe2 Vertical Heterostructure: A Molecular Dynamics Study", Computational Materials Science, 188, Pp. 110231, (2021).

 

 

Send comment about this article
Enter Name.
Enter a valid email address.
Enter a vaid affiliation.
Enter comments (At leaset 10 words)
CAPTCHA Image
Enter Security Code Correctly.