Journal Of Applied and Computational Sciences in Mechanics

Journal Of Applied and Computational Sciences in Mechanics

Vibration Cutting and Elliptical Ultrasonic Vibration Assisted Turning of In738 Work-Pieces

Document Type : Original Article

Authors
Saeed Amini
Mohammad javad Nategh
amir abdollah
10.22067/fum-mech.v23i2.16772
Abstract
Vibration cutting (VC), elliptical vibration cutting (EVC) and ordinary cutting (OC) of In738 work-pieces have been experimentally investigated in the present research. The experiments were carried out by using single crystal diamond tool and ultra-precision CNC lathe. Vibration frequency is 36.16KHz and the amplitude is . The influence of various cutting parameters including cutting speed, feed-rate, vibration amplitude and phase angle on the cutting force, surface roughness and tool life have been studied and the results have been compared. The results indicate that the cutting force in EVC is much less than the two other processes. The surface roughness in both the cutting and feed directions was also less than those in other processes.
Keywords
Vibration cutting (VC)
elliptical vibration cutting (EVC)
In738 machining
Send comment about this article
Enter Name.
Enter a valid email address.
Enter a vaid affiliation.
Enter comments (At leaset 10 words)
CAPTCHA Image
Enter Security Code Correctly.